- BuildingDesign Construction Portal
  • Request Product Information
  • Connect With Us
  • Follow BuildingDesign on Twitter Connect with BuildingDesign on LinkedIn Become a fan on Facebook Follow BuildingDesign on Pinterest instagram

Eurovac - Vacuum Drainage Technology

Vacuum Drainage Technology - EVAC Vacuum Toilet System - EVAC Systems - EVAC Toilets - Applications & Advantages

Applications & Advantages

The building sector has been slow to move to vacuum drainage technology, but with the confines placed on new projects such as small conduit and service ducts and the growing awareness of the need to limit water consumption, the system is now finding a place in the building sector. As the system is capable of lifting sewage from appliances such as WCs and running in voids above these appliances, the system offers the designer greater flexibility and freedom to position appliances where most suitable for the building.

The Evac Vacuum Toilet System could not be simpler. Instead of relying on traditional solutions which use the principle of gravity to remove waste and are heavily reliant on the location of service cores and outgoing sewer connections, the Evac system creates a powerful vacuum to flush the toilet which works like this...

Once the flush button is pushed, a pneumatic signal is sent to the control mechanism which opens the discharge valve by allowing a vacuum from the pipework system to enter the discharge valve diaphragm, thus connecting the bowl to the vacuum system. Air at atmospheric pressure then forces sewage through the discharge valve and into the piping.

The water valve is opened, and pressurised rinse water cleans the bowl simultaneously. The whole operation is performed using just vacuum – NO electrical connections are required.

Evac toilets can be re-flushed more than 4 times faster than conventional gravity toilets; on average, an Evac toilet will take 5 seconds to complete a flush cycle as there is no toilet cistern to refill.

Evac systems also reduce leakage problems. The problem of leakage due to pipe fracture is reduced – as a vacuum exits throughout the system, any leakage is directed inward rather than outward.

Whilst the Evac vacuum toilet is an integral part of the system, the system will also accept waste from all other gravity fixtures, including wash basins, baths and showers using a Vacuum Interface Valve which is similar in operation to the Evac vacuum toilet. The manually operated push button is replaced by an activator which is triggered when a static head has been built up in the grey water tank.

The whole operation is automatic, and no electrical connections are required. The valves allow standard bathroom fittings to be connected to the vacuum drainage system in new build projects and eliminates the need to replace existing fittings in a refurbishment project.

Evac gives the building designer complete freedom from the restrictions of gravity fed plumbing. Bathrooms and toilets do not need to be tied into a services core but can be located where best suits the design.

Increased Design Flexibility

Evac toilets can be installed just about anywhere in a building. Pipes are small bore (normally 50-75mm) and can be routed around and even over obstructions. As they are not reliant on the locations of service cores and do not need vent stacks, design flexibility is maximised. Anywhere you can imagine an Evac toilet system in the design of your new build or refurbishment project, it can be achieved.

Evac systems are not dependent on gravity; therefore waste pipes do not need to slope downwards which means that Evac toilets can flush along the level – even upwards when downward flushing is inconvenient. This opens a wealth of design opportunities, especially in refurbishment, extensions and retro-fit projects.

Evac systems give vertical lift of up to 5m, giving unparalleled flexibility in installation. Toilet cubicles, urinals, showers and hand basins can be positioned wherever you want, regardless of conventional soil stack practice. As there is no need to be adjacent to a central soil stack, the location of toilet accommodation can vary from floor to floor.

In speculative buildings, a prospective tenant will often wish to plan the space available in a building to suit its business operation. The Evac system gives you this extra capability. Final decisions on the floor plan can be delayed leaving maximum room to manoeuvre and giving the client maximum flexibility to plan space.

Health & Hygiene

Unlike conventional toilets which permit bacteria and odours to enter the atmosphere, the Evac toilet takes out up to 100 litres of air on each flush, removing viruses, bacteria and odours from the bowl and into the system. This cycle of air will keep the toilet accommodation fresh, enhancing hygiene and personal comfort within washrooms. As the complete pipe work system is held under a vacuum, it is impossible for infestations or rats to live and breed in the drainage. Every Evac system, when installed, is a closed loop. This is particularly important where an organisation requires waste to be contained if contamination is considered high risk e.g. hospitals, research facilities and prisons.

Water Savings & Energy Consumption

Water and energy consumption will be dependent on the size, type and use of the building and its vacuum drainage system. Evac systems are very environmentally friendly – one of the biggest savings on natural resources is the dramatic reduction in water consumption. A conventional toilet consumes between 4.5 and 6 litres of water every time it is flushed. The Evac toilet typically uses just over one litre of water per flush – 1/6 of that used by a conventional toilet. Using less water will bring significant cost savings as water rates rise and as Evac toilets have very low water consumption, the actual amount of sewage produced is also reduced, helping to ease the burden on overloaded public sewage plants. Vacuum retention tanks can also be discharged during off-peak periods.

Total Water Cycle

When considering a vacuum toilet system and comparing it against a gravity system, you must compare the complete water cycle. There is a saving in both the cost and power by bringing less water into your building. If that water must be stored in the building, then the use of vacuum toilets will reduce the size of any storage tanks, freeing up valuable floor space or reducing excavations for underground tanks. If the tanks are to be sited at the top of the building, the structural requirements of the building can also be reduced.

Once your water is in the building, you will have to move the water around it. The larger the building, the more power will be consumed in this process, so the small amount of water that you must move, the less power you will need to consume.

After the water has been used to flush a toilet, it must be disposed of. In large buildings with conventional gravity toilets, this can mean several sewage pumping stations located around the building to get the sewage from the building into the main sewer. By consuming less water, the vacuum toilet system also produces less sewage. The flexibility of a vacuum drainage system means that all the sewage from the building can be brought back to one location in the building. If the black water is to be treated in-house then the lower level of sewage will impact on the size and type of sewage treatment plant required, saving costs, space and energy.

The Hospital Club Covent Garden - London

This building was originally opened in 1749 as the British Lying-In Hospital and remained one of London’s principle maternity facilities until 1913. It became a military hospital during the First World War prior to being sold for £15,000 in 1919 to St Paul’s Hospital. It remained a medical centre until 1992 when the services were transferred to the Middlesex Hospital.

The building sat idle and fell into disrepair for over a decade until in 2004 after a collaboration between Dave Stewart from the musical group The Eurythmics & Paul Allen co-founder of Microsoft re-launched it as a hub of creativity - full of people, ideas, music and life. The Hospital Club was born. The building includes bars, restaurants, meeting rooms and a full TV studio where many main stream TV shows are filmed. In 2014 and due to its success, the club decided to convert one of the floors that was their admin centre into a 16-room hotel. The design was to create a variety of rooms and two suites. However, with the noise being created from the high energy produced on the areas below, the floor had to be sound proofed to create the right ambience for a hotel. Penetrating this floor to allow for gravity fixtures was not possible, so the public health designer Cudd Bentley proposed a vacuum drainage system that would allow the drainage to be lifted to high level and then routed to a pre-built sound protected riser. The vacuum drainage system caters for all 16 rooms draining the toilets, wash basins and baths. Evac’s range of interface units allows for shower waste collection in both the standard and disabled rooms. The Evac vacuum system does not impact on the aesthetics of the room and blends with the interior designers’ vision.

Vacuum Drainage

Request Eurovac Info

European Vacuum Drainage Systems
Unit 35 Lordswood Industrial Estate Gleamingwood Drive

Email Eurovac

Tel: 01634 684 779
Fax: 01634 661 510

View / Print Content (PDF)

Click to Enlarge

Request Information From Eurovac - for UK and Europe only

  • *Full Name
  • *Company Name
  • *Telephone
  • *Email
  • *Enter Short Description of Your Requirements
Please tick below to indicate how Eurovac may contact you. You may leave any box blank.
  • By Email
  • By Post
  • By Phone
  • By SMS

To Subscribe to our twice-weekly BuildingDesign e-Newsletter tick here:

  • * Please enter numbers shown for validation purposes
We will not share any of your details with any third parties or subsidiaries. You have the right to withdraw or change your consent at any time by contacting Eurovac. Company details can be found here »

Click here to read our Privacy Notice »